Filters

Secure Checkout
BRP Hot Rods - The Pro's Choice for LS & LT Swap Kits and Swap Parts!
Your Shopping Cart Is Empty

1955 - 1957 Chevy LS Gauge Components

Swapping an LS into a 1955, 1956 or 1957 Chevy and keeping a tach in the dash takes a signal fix, because the LS has no distributor. BRP stocks a tach adapter for that and a fitting so a traditional oil pressure gauge sensor can go in the block.

  • Drives a traditional tachometer
  • Custom wiring, no BRP harness
  • Takes a traditional pressure sensor

The Tri-Five kit, crossmember, headers and fuel parts are on the 1955-1957 Chevy LS page. Gauge parts for other cars are under LS swap gauge components.

1955-1957 Chevy LS gauge parts

Tachometer adapter

Oil pressure sensor fitting

What these Tri-Five gauge parts do

  • Tach Adapter: reads the distributorless LS and sends a signal a traditional tach or shift light can follow.
  • Oil Pressure Adapter Fitting: adapts the LS so it accepts a conventional gauge sensor.

Tri-Five gauge notes

  • Plan your own tach wiring. This listing leaves the BRP LS harness out.
  • Bel Air, 210 and 150 swaps all use the same two parts. Neither is made for Tri-Five cars only.
  • Gauge hookup is not part of the 1955-1957 Chevy LS guide.

Product facts come from the BRP listings. Chassis steps are in the 1955-1957 Chevy LS install guide.

1955-1957 Chevy LS gauge FAQ

Will a tach work in my 1955-1957 Chevy after an LS swap?

A traditional tach needs a conventional signal. The Tach Adapter creates one from the distributorless LS so a factory or aftermarket traditional tach, or a shift light, reads rpm.

Is there a harness in the box?

No. This Tach Adapter is the version without the BRP LS harness.

What do I need for an oil pressure gauge on a Tri-Five LS?

The Oil Pressure Adapter Fitting. It lets the LS take a traditional pressure gauge sensor.