LS swap exhaust parts for finishing the system behind your headers or manifolds: cast iron exhaust manifolds for LS engines, stainless band clamps in 2-1/2 and 3 inch, 3 inch to 2-1/2 inch cone reducers, a 3 inch O2 sensor band clamp and stainless steel header bolts.
Looking for headers? Shop LS swap headers by vehicle. Building the whole swap? Start in the LS swap kit builder.
Cast iron LS exhaust manifolds come as a pair with weld-on flanges, gaskets, bolts and studs, for a swap that skips headers.
Band clamps, cone reducers and an O2 sensor clamp join the header or manifold outlet to the rest of your exhaust.
The reducers step a 3 inch outlet down to a 2-1/2 inch pipe.
Manifold contents and applications come from the product listing. Header and chassis notes come from the BRP chassis install guides.
The listing names 15 applications, from the 1953-1982 Corvette and 1955-1957 Chevy to A, B, F and G-Body cars, GM trucks from 1963 to 1998, the G series van and the Vega and Monza.
Yes. You get both manifolds, flanges to weld to your exhaust, gaskets, and the bolts, studs and hardware.
There is a 2-1/2 inch and a 3 inch stainless band clamp, plus a separate 3 inch band clamp for an O2 sensor.
In some chassis. The 1988-1998 GM truck guides say factory LS truck exhaust manifolds fit, while the 1994-1996 B-Body LT guide says factory truck LT manifolds do not.
© 2026 . All Rights Reserved. Powered by Miva