3 Inch O2 Sensor Band Clamp for LS Engine Swaps
Tackling precise exhaust sensor placement is a common challenge in LS engine swaps and the 02 Sensor Band Clamp - 3 Inch simplifies this step. Its design fits standard 3 inch exhaust tubing without welding, allowing you to secure the sensor bung in minutes. A built in gasket seals against leaks during heat cycling while stainless steel construction guards against corrosion and fatigue. By keeping O2 sensor alignment precise at the pipe wall, it delivers reliable oxygen readings for accurate engine management.
Precision Alignment for Accurate O2 Readings
The integrated O2 sensor bung and matching gasket position the sensor precisely against the pipe wall, ensuring consistent contact and correct depth. This alignment produces reliable voltage signals that allow the engine control unit to fine tune the air fuel ratio under all driving conditions. By preventing sensor tilt or offset, the design avoids false lean or rich readings that can lead to poor performance or trigger error codes. The leak-proof gasket maintains a stable seal through repeated thermal cycles, preserving sensor accuracy over time.
Premium 304 Stainless Steel for Lasting Durability
Constructed from high-grade 304 stainless steel, this band clamp resists corrosion, oxidation and damage from road debris. The material retains tensile strength at elevated temperatures, preventing deformation and fatigue in performance or off-road use. Its corrosion resistance also stops rust from compromising the clamp's grip or sealing surface. Over years of heat cycling and vibration, the stainless steel body remains dimensionally stable, keeping the sensor firmly in place.
Welding Free Setup Streamlines Sensor Mounting
Thanks to its clamp-on design, installing the band clamp requires only basic hand tools-no torch or welding skills needed. The pre-installed bung accepts any standard O2 sensor, eliminating the need to source separate bungs or schedule shop time. Simply slide the clamp over 3 inch tubing, align the sensor position, tighten the fastener and you're ready to go in minutes. This approach reduces installation labor, avoids heat-induced warping of the exhaust tube and makes future sensor swaps quick and clean.
Built for straightforward installation and reliable sensor performance in your LS swap.