High-Flow LT Fuel Pump and Installation Fittings for GM Models
For LT conversions from 1991 through 2005 GM vehicles where factory pumps run dry, the 340 LPH Fuel Pump and fitting kit restores fuel pressure across the rev range. Featuring a 340 liter per hour rating and designed for 12 volt factory harnesses, this assembly holds pressure from idle throttle tip in city driving to sustained full throttle pulls. Each adapter and hose fitting matches factory rail ports on Camaro Firebird and GM truck models with no extra hardware or drilling for a true plug in installation. Built with corrosion resistant internals and an integrated debris screen, the pump resists cavitation and supports both naturally aspirated and boosted LT applications on street or track.
Factory Boss Alignment for Reliable Belt Tracking
The bracket is precision machined to match the bolt pattern on 2016 and newer Camaro engine blocks and chassis rails, ensuring a direct fit with no drilling or modification required. This exact alignment keeps pulleys in their intended positions under varying loads, so belts maintain proper seating and tension through every shift in engine speed. By preserving the original mounting geometry, the design reduces lateral stress on accessory bearings and hoses, extending service life and cutting down on maintenance. Installers gain confidence from a predictable fit that removes trial and error when routing belts for the steering pump and AC compressor.
Aircraft Grade 6061 T6 Aluminum for Strength and Weight Savings
Constructed from 6061 T6 aluminum, the bracket meets strict aviation standards for yield strength and fatigue resistance, delivering a robust support structure that resists flexing under heavy loads. Its favorable strength to weight ratio minimizes added mass in the engine bay while maintaining the rigidity needed to support both the steering pump and compressor. Natural corrosion resistance protects the assembly from road salt, humidity, and heat, preserving finish quality and structural integrity over time. The careful choice of material helps maintain crisp steering response and consistent accessory drive even during the most demanding driving scenarios.
Comprehensive Component Kit for Simple Bolt On Assembly
This kit brings together every part required for a seamless installation, including the power steering pump bracket, remote reservoir mounting brackets, idler pulleys, precision spacers, and all necessary hardware. Each spacer is CNC cut to position components at the exact height and angle dictated by factory bosses, preventing misalignment and belt slip. Preassembled pulley hardware and pretested fasteners guarantee correct clamp force, letting technicians complete the process in a single session without sourcing additional parts. The all in one approach not only saves bench time but also eliminates compatibility guesswork that often arises when mixing aftermarket pieces.
Engineered Durability for Street and Track Applications
The bracket system is designed to handle the full spectrum of driving demands, from daily errands to spirited track outings, without compromise. Its rigid design endures repeated heat cycles from engine warm-up to high rpm sessions, keeping accessory belts accurately tensioned mile after mile. Rigorous quality checks during production verify dimensional accuracy and material integrity for every unit, so drivers can trust steady steering feel and reliable compressor operation. This level of craftsmanship ensures consistent performance through wet weather, temperature swings, and the increased load of performance driving.
Count on dependable belt alignment and corrosion resistance for enduring performance.